SCOPE + (HU31025)

• Solely designed for automotive electrical circuit’s troubleshooting.
• Easy and simple to use, no extensive electrical knowledge needed.
• Fully protected. It will not cause damage, even accidentally using OHM measurement to measure Volts.

Measures:

• Amps draw (mini, ATC or maxi) without removing the fuses from the fuse box
• Voltage (max. 50 VDC)
• Cranking volts with auto HOLD function
• Resistance [Ohms] (from 0.0 Ω up to 1.0 MΩ)
• Frequency with peak to peak volts (up to 20 KHz)
• Duty cycle (%)
• Continuity test + Diode/ LED test

_____________________________________________________________________

SENSOR SIMULATOR (HU31035)

The ideal tool to simulate and actuate the output signal from automotive sensors : frequency, voltage and test sequences

• It will help you in your diagnostic when scan tool diagnosis ends. Sensors, injector actuators will inform the scan tools that there is a problem, but the sensor simulator will allow the technician to know if the faulty operation is a faulty sensor, a problem in the car computer, a defect in the wiring, etc.
• The device is specially used for wiring tests. It can simulate the correct signal and compare it to the scan tool.
• Allows you to eliminate the need to replace sensors that work perfectly fine (investment quickly pays for itself).
  
  Simulator functions
  1. Simulated resistance
  2. Simulated voltage
  3. Simulated sine wave
  4. Simulated square wave
  5. Simulated temperature coefficient sensors:
  6. Simulated throttle & pedal sensor sequences
  7. Oxygen sensor : testing mode and simulated mode
  
  
• You can simulate most sensors, injectors or actuator as ABS sensor, lambda sensor, EGR sensor, CKP sensor, knock sensor, map sensor
• To be used in combination with the HU31025 Scope +