Aussteller & Produkte 2024

NewDimension 3D achsvermessung

Beschreibung

TheVamag New Dimension 3D wheel alignment system is the result of the higher company resources investment, which covers the instrument with 6 International Patents.

An ambitious project developed with the experience of Vamag developers and the proprietary data-processing software which allowed the realization of one of the more rapid and precise 3D vehicle’s geometry measurement system in the market.

Floor / ceiling installation or using stand mounted on the floor, the New Dimension has been able to suit the most complex standard of some countries and the most different workshop layouts.

The direct vision technology using high-resolution cameras and its particular predisposition for side view of the target applied on vehicle’s tyres, which make it a drive-through system, take undeniable advantages in terms of data acquisition speed and linear measurement precision.

Data visualization software with 3D graphics and Autodata databank, both updated by web, allow to access to always-updated information of the available measurements and regulations.

Instant alignment data acquisition - Run-out compensation can be skipped.

Thanks to the ND system, the Patented measurement method and the hang-on-tyre clamps, the operator can skip run-out compensation without losing any precision! ALL THE DATA CAN BE MEASURED IN LESS THAN 30 SECONDS.

New Vamag Patented technology
High-resolution camera acquisition system
Instant alignment data acquisition
Versatile installations
Full clearance of the working area
No need for run-out compensation (it can be done, if needed)
Drive through bay
Lift-independent
Wide selection of clamps
Option: RoboSterz for complete automatic procedure
& much more...

VERSATILE INSTALLATION

The new entry in the VAMAG range of NewDimension 3D wheel aligners to fulfill the market request for a competitive full 3D without the burdens of traditional technology.

Floor, ceiling and wall installation for full clearance of the working area
Versatile installation to fit any workin’ bay layout
Side way positioned camera heads to allow flexible installation
Possibility to install it with scissor, pantograph, 2 - 4 columns lifting device and pit
Quick alignment check by means of comprehensive measurement display
Accurate adjustment using single wheel display
Friendly software for easy operations

FREE WORKING AREA with no obstacle for the operator to move around.

DRIVE THROUGH BAY: Possibility to install it in any part of the workshop (both with a lift or in a pit). Camera heads are located on either sides of the working bay.

FULL CLEARANCE OF THE WORKING AREA. Camera heads positioned at 2,4 meters height (ND-C) on either sides of the working bay, at 90 - 140 cm distance from the lift.

LIFT INDEPENDENT: Possibility to install the ND with any kind of lift. Camera view is not affected by lift columns.

WIDE CAMERAS FIELD OF VIEW: Fixed cameras reading values during the whole wheel alignment procedure. Full clearance of the working area

THE MEASUREMENT SOFTWARE:

Intuitiveandfriendly
Software-driven operations
Easy-graphic icons simplify operational procedures
Instant parameters acquisition and display
3D graphics

AUTOMATIC CASTER SWING

Caster swing can be performed at 6°- 10°- 20°. There’s no need to set up the degrees from the settings, simply click on the icon to change the value.

Using the RoboSterz (Patented robot which makes the caster swing automatically) the procedure is 100% automatic and the operator can save a lot of time doing other works in the meanwhile the robot is working.

RoboSterz also allows one-man operation.

ANGLES